Happymodel Crux35 ELRS V2 Analog / Crux35 Digital HD 150mm 3.5 Inch 4S Ultralight FPV Racing Drone BNF w/ CADDX Nebula Pro / ANT 1200tvl Camera
NOTICED:
SPI ELRS version Crux35/Crux35 HDZERO/Crux35 HD were discontinued. The new ELRS V2 version comes with CrazyF411 ELRS AIO flight controller built-in UART ExpressLRS receiver.
Feb. 11th, 2023
Introduction:
CRUX35/CRUX35 HD is an ultra-lightweight 3.5Inch FPV Freestyle FPV Racing Drone, the weight of the whole drone is only 87g for the analog version and 108g for the digital HD version. The Crux35 serials drone use Happymodel EX1404 high-efficiency motor and HQPROP 3.5-inch three-blade propeller to ensure the largest thrust-to-weight ratio under the most efficient premise, which can bring you a smooth Freestyle flying experience.
The HD version is equipped with CADDXFPV Nebula and Vista HD image transmission system. The analog version is equipped with CADDXFPV Ant ant camera.The receiver version can be SPI ExpressLRS and SPI Frsky (S-FHSS compatible) for choose.ExpressLRS is the most popular RC link system by now , it could performance very well with Crux35 and Crux35 HD.
Features:
Ultra-lightweight 3.5-inch BNF FPV Freestyle Drone
HD video transmission and analog video transmission are optional
Integrated ExpressLRS SPI receiver or Frsky SPI D8/D16 receiver
High efficiency EX1404 power system
Can be equipped with Naked Gopro or SMO4K
Support 3-4S battery 4S 750mah battery is recommended, maximum support 4S 1100mah
Specifications:( Manual of ELRS Version / Frsky Version)
Brand:Happymodel
Model:Crux35 Analog / Crux35 HD
Wheelbase:150mm
Weight:87g ( Analog); 108g ( HD)
Size:130mmx130mmx45mm(without propellers)
Version Optional:Analog / HD
Receiver optional:UART ExpressLRS 2.4GHz (ELRS 2.4G RX) / SPI Frsky D8/D16 (S-FHSS compatible)
Camera option:HD version Nebula+Vista
Analog version Ant+OVX303 VTX
Flying time:9min~15min 4s 750mah battery
Motor | Mode:EX1404 KV options:KV3500 Configu-ration:9N12P Stator Diamter:14mm Stator Length:4mm Shaft Diameter:??1.5mm Motor Dimension(Dia.*Len):??15mm*15mm Weight:9g |
Propellers | Propeller Diameter:3.5 inch Pitch:2 Blades:3 Material:Poly Carbonate Weight:1.5g Hub Diameter:10mm Hub Thickness:4.7mm Shaft:1.9/1.5/1.9mm Adaptor Rings:NO |
Flight controller (ELRS Version) |
MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor:ICM42688P or BMI270 (SPI Control) Mount pattern:25.5?G25.5 M2 Size:32*32*5mm Power supply:2-4S Lipo battery Built-in 20A Blheli_s ESC each Built-in Betaflight OSD(SPI Control) Built-in UART ExpressLRS 2.4GHz receiver Built-in 5V 1.5A BEC Flight controller firmware target:CRAZYBEEF4DX |
Flight controller (Frsky version) |
Model:CrazybeeF411 FRSKY MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor:BMI270 or ICM42688P(SPI connection) Board size:28.5 * 28.5MM Power supply:2-4S battery input (DC 8V-17V) Built-in 20A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Frsky D8/D16 SPI receiverBuilt-in 2.4G Power Amplification Built-in Betaflight OSD(SPI Control) Built-in Current meter Built-in 5V 1.5A BEC Built-in voltage detectionFirmware target:MATEKF411RX |
Onboard 4in1 ESC | MCU upgraded to EFM8BB21 Power supply:1S LiPo/LiPo HV Current:5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware:O_H_5_REV16_8.HEX Default protocol:DSHOT300 |
Onboard UART ExpressLRS 2.4GHz Receiver (ELRS 2.4G Receiver version) |
Packet Rate option:25Hz/50Hz/150Hz/250Hz/500Hz RF Frequency:2.4GHzAntenna plug:IPEX Telemetry output Power:<12dBm Receiver protocol:CRSF Default firmware version:ExpressLRS V3.0.1 |
Onboard SPI Frsky 2.4GHz receiver ( SPI Frsky Receiver Version) | SPI BUS receiver Frsky D8/D16/EU-LBT/, Futaba S-FHSS switchable on Betaflight Channels:8ch/16ch Dual antenna Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground):400m |
Caddx FPV Digital HD Camera Nebula Nano Kit (Digital HD version) |
Weight(camera included]:24g Antenna:2.3g Dimensions:Vista Kit 30?G29?G13mm Camera 14?G14?G21mm Operating Frequency:5.725-5.850GHz Transmitter Power[EIRP]:FCC/SRRC/MIC:<30dBm CE:<14dBm Min.latencylend-to-end) 720p 60fps:32ms Max.Transmission Distance FcC/SRRC:4km CE:0.7km lnput Power:7.4-26.4V Power Output:25mW/200mW/500mW/700mw Goggles:Work with DJl goggles Camera Sensor:1/3??CMOS Lens:2.1mm,f/2.1 Shutter:Rolling shutterFOV:142??(D);122??(H);75??(V) LHCP antenna |
Caddx ANT 1200tvl camera (Analog version) |
Image Sensor:1/3′ CMOS Sensor Horizontal Resolution:1200 TVL TV System:NTSC or PAL IMAGE:16:9 or 4:3 Synchronization:Internal Electronic Shutter:PAL:1/50~100,000; NTSC:1/60~100,000 S/N Ratio:>52dB (AGC OFF) Video Output:CVBS Lens:1.8mm Min. Illumination:0.001Lux@F1.2 Auto Gain Control:YES BLC:YES WDR:Global WDR DNR:3D DNR Dimensions:14*14mm(with bracket to 19*19mm) Wide Power Input:DC 3.7-18V Work Temperature:-20??~+60?? Weight:2g (N.W.) |
OVX303 5.8Ghz VTX (Analog version) |
Model:OVX303 Frequency:5.8G 40CH Transmitting Power:0/RCE/25mw/100mw/300mw Power supply:DC 5V Current (5v):<650ma (300mw) Weight:1.5gram without antenna |
Recommended(Not Included):
4S:750mah Battery
Package Included:(Optional)
Analog
1x Crux35 Frame
1x Analog FPV Camera Caddx Ant
1x Happymodel OVX303 5.8G analog VTX
4x Happymodel EX1404 KV3500 brushless motor
1x HQProp T3.5X2X3Grey (4cw+4ccw)
1x Screw Driver
1x Buckle for battery
Option1:CrazyF411 ELRS FC with UART ELRS
Option2:CrazyF411 FRSKY FC SPI Frsky
HD
1x Crux35 Frame
1x CaddxFPV Digital HD Camera Nebula Nano Kit
4x Happymodel EX1404 KV3500 brushless motor
1x HQProp T3.5X2X3Grey (4cw+4ccw)
1x Screw Driver
1x Buckle for battery
Option1:CrazyF411 ELRS FC with UART ELRS
Option2:CrazyF411 FRSKY FC SPI Frsky
Additional information
Weight | 0.108 kg |
---|---|
Version: No selection | Analog, HD |
Receiver: No selection | ELRS 2.4GHz, SPI FrSky |
Reviews