30.5×30.5mm Holybro Kakute H7 V1 Flight Controller and Tekko32 F4 4in1 50A ESC Stack for RC Drone FPV Racing
Specification:
Brand:Holybro
Model:Kakute H7 V1 Stack
Kakute H7 V1 Flight Controller ( Manual) |
MCU:STM32H743 32-bit processor running at 480 MHz IMU:MPU6000 Barometer:BMP280 OSD:AT7456E Onboard Bluetooth chip:ESP32-C3 SpeedyBee IOS & Android App Compatible Note:The Bluetooth onboard is set to automatically turn off when the flight controller is unlocked (arm) and turn on automatically when the fc is locked (disarm). 6x UARTs (1,2,3,4,6,7; UART2 is used for Bluetooth telemetry) 9x PWM Outputs (8 Motor Output, 1 LED) 2x JST-SH1.0_8pin port (4in1 ESCs, x8/Octocopter compatible) 1x JST-GH1.25_6pin port (For HD System like Caddx Vista & Air Unit) Battery input voltage:7V to 42V BEC 5V 2A Cont. BEC 9V 3A Cont.(Updated) Mounting Hole:30.5 x 30.5mm/?4mm hole with ?3mm Grommets Dimension:35x35mm Weight:8g Firmware Target: BetaFlight:KakuteH7 (v4.2.11 and above) INAV:KakuteH7 (4.0.0 & above) SD card support added in 4.1.0. ArduPilot:KakuteH7 (4.2.0 & above) |
Tekko32 F4 4in1 50A ESC ( Pins Instruction) |
Continuous Current:50A x4 Burst Current:60A x4 Supports 4-6S battery Supports DShot 150/300/600/1200 & MultiShot/OneShot/Proshot/PWM etc. ESC telemetry Supported Onboard analog current sensor No output BEC BLHeli_32 firmware 1000uf 35v capacitor included (highly recommended for 6s setup) Amperage meter scale ratio:168 Dimensions:45x37x6mm / Weight:13.8g Mounting holes:M4 30.5×30.5mm (M3 grommets included) Features: New and faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz) PWM Frequency:16k to 96k Separate drive & control circuit, this broadens the current capability of the drive circuit while reducing the electrical interference to the control circuit. |
Pakcage Included:
1x Kakute H7 V1 Flight Controller
1x Tekko32 F4 4in1 50A ESC
1x Set of Cable
Additional information
Weight | 0.1 kg |
---|
Reviews