Happymodel Moblite7 V2.0 Walksnail 1S 75mm HD Whoop FPV Racing Drone with Walksnail Avatar Nano HD Digital System
V2.0 update log:
1. Changed to GNB27 connector and V4 frame, no need 3d print battery tray anymore.
2. Changed the propeller to Gemfan 1635-3 propellers.
NOT Included Lipo battery!
Specification:
Brand:Happymodel
Model:Moblite7 Walksnail
Item Name:1S 75mm HD Whoop FPV Racing Drone
Frame wheelbase:75mm
Weight:33.5 gram without battery
Size:98mm*98mm*48mm
Receiver option:
SPI ELRS 2.4GHz
SPI FRSKY 2.4GHz
Compatible with 1S Lipo battery or Lihv battery
Battery Plug:GNB27
| Flight controller SuperbeeF4 Lite ELRS/FRSKY |
SPI ELRS version Firmware target:CrazybeeF4SX1280 SPI FRSKY version Firmware target:CrazybeeF4FR MCU:STM32F411CEU6 (100MHz, 512K FLASH) Sensor:MPU-6000 or ICM20689 or BMI270(SPI connection) Power supply:1S Lipo Lihv battery input (DC 2.8V~4.35V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in SPI Frsky/ExpressLRS receiver Built-in 5V 1A BEC Built-in voltage detection |
| Onboard 4in1 ESC | MCU upgraded to EFM8BB21 Power supply:1S LiPo/LiPo HV (2.8v~4.35v) Currents:5A continuous peak 6A (5 seconds) Support BLHeliSuite programmable Factory firmware:O_H_5_REV16_8.HEX Default protocol:DSHOT150/DSHOT300/DSHOT600 |
| Onboard SPI ExpressLRS 2.4GHz Receiver | Packet Rate option:25Hz/50Hz/150Hz/250Hz/500Hz RF Frequency:2.4GHz Telemetry output Power:<12dBm Receiver protocol:SPI ExpressLRS Could bind with ELRS V2.0 firmware TX module |
| Onboard Frsky SPI D8 /D16 2.4GHz Receiver | SPI BUS receiver Frsky D8/D16 compatible Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt) Channels:8ch or 16ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground):100m~200m Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol |
| Motor | Model:RS1002 20000KV Configu-ration:9N12P Stator Diameter:10mm Stator Length:2mm Shaft Diameter:??1.5mm Motor Dimension(Dia.*Len):??13.5mm*12.5mm Weight(g):2.5g No.of Cells(Lipo):1S only |
| Propeller Gemfan 1610-2 Bi-blades ( V1 ) | Weight:0.24g Material:PC Pitch:1 inch Props Dia:40mm Center Hole Dia:1.5mm |
| VTX | Model:Avatar mini 1s module Communication Frequency:5.725-5.850 GHz Transmitter Power(EIRP):FCC:<25.5dBm; CE:<14dBm; SRRC:<20dBm;MIC:<25dBm l/o Interface:JST1.O*6(Power in)JST1.O*4(USB) Mounting Holes:25.5*25.5 mm Dimensions:33*33*6.5 mm Storage:8G Recording:1080p/720p Weight:6.8 g Operating Temperature:-20-40?? Channels:8 Wide Power lnput:3.1V-5V Supported FC System:Betaflight OSD:Canvas mode Bitrate:25mbps / 50mbps Latency:Average delay 22ms Antenna connector:IPEX |
| FPV Camera | Model:Avatar nano lmage Sensor:1/2.7??Inch Resolution:1080P/6Ofps,720P/120fps,72OP/6Ofps Ratio:16/9 4/3 Lens:2.1mm FOV 170?? Aperture:F2.0 Shutter:Rolling shutter Min.Illumination:0.001Lux Weight:3.5g Dimensions:14*14*17mm Coaxial Cable:45mm |
Package Included:
1x Moblite7 V2 Walksnail FPV Drone
1x Spare Canopy
1x Propeller disassemble tool
1x Screw driver
Additional information
| Weight | 0.1 kg |
|---|---|
| Receiver: No selection | Compatible Frsky Receiver, ELRS 2.4GHz |
Reviews
There are no reviews yet.