Flipsky 200A ESC Dual FSESC6.7 with Aluminum Heatsink for Electric Surfboard RC Car Drone E-Bike

Flipsky 200A ESC Dual FSESC6.7 with Aluminum Heatsink for Electric Surfboard RC Car Drone E-Bike
Description:
Advanced Features:
Dual ESC can reach continuous 200A big current, give your board strong power
One PCBA board integrate two FSESC6 ??s function by internal CAN BUS circuit connection.
The main and slave board connection can be switched On/Off
Preserve Bluetooth module and RF module connections for both master and slave board
Aluminum anodized Heat sink with fins design for better heat dissipation
Size with heatsink:128.5x91x21mm (L*W*D)
PCB layers:8layers, thickness:3oz/layer, total 24 oz thickness
Spec:
Hardware:V 6.6
Eprm:150000
Firmware:Latest firmware version
Voltage:8V – 60V (Safe for 3S to 12S LiPo) for the dual ESC
Voltage spikes may not exceed 60V
Current:Continuous 100A single, total 200A , Instantaneous current 400A per single, total 800A for system instantaneous current. values depend on the mounting and ambient temperature around the device
5V 1.5A output for external electronics for single
3.3V 1A output for external electronics for single
Modes:DC, BLDC, FOC (sinusoidal)
Supported sensors:ABI, HALL, AS5047
6 shunts in dual system. Each is measurable for the current.
Recommend bullet connectors:5.5mm Special Banana Connectors
Motor wire:10AWG
Power cable:8AWG
Note:
1. Detected battery voltage tolerance:+/-0.6V
2. This version doens’t support setup for 4WD
If you want to set up 4WD, get the dual fsesc6.6 plus based on vesc,not this one
Wiring Diagram Please Click here
Package Included:
1X Dual FSESC6.6 + Heatsink
2X Sensor Wires
1X Mirco USB
1X Manual

Additional information